CMU-02

WRE-02

WCP-02

BTXV-NCT

ILB-03 SIGNAL REPEATER & ALARM

The components shown on the right are usually all that is required for most nurse call systems. The BTXV-NCT is the patient call button transmitter. The WCP-02 and the WRE-02 form a W/C, bath or shower room alarm with wireless reset function. The CMU-02 displays patient call information including zone location with bed or room number. The ILB-03 is a combined signal repeater with flashing light and audible alarm. The system uses the latest supervised radio technology to monitor and report the status of all system components including low battery warnings and missing or broken items.

All systems are set up in our factory prior to dispatch to your premises unless ordered through a contractor. Any reasonably competent handyman can install the system as no electrical wiring or technical setup procedures are involved. The bedroom call points requiring only a simple wall fixing then the insertion of a battery. The nurse call display is powered from an AC power adaptor with battery back up provided by 4 x D cell batteries. A wall fixing bracket is provided for quick installation. The pull cord transmitter for W/C and washroom use and the wireless reset button are powered by 2 x 3V lithium batteries, which are sealed in and give a five year operating life cycle.  

If required, a low cost pager(s) can be used with the call point transmitters. The pager (PAG-02) has a built in voice chip that announces bed numbers. Any number of pagers can be used with a system and no setup is required. The PAG_02 operates from 2 x AA batteries and can be set to announce bed numbers in various languages. The pager has a volume switch with three volume settings, low, medium and high (quite loud).

Pricing information and order codes is set out below. If you wish to view technical details concerning all products, click HERE

Patient nurse call point transmitter with three Metre switch lead.  Transmitter can also be used with bed or chair occupancy sensors. Staff emergency call button. Transmitting range 100M. ORDER CODE BTXV-NCT PRICE £56.00

Wireless pull-cord transmitter for use in W/C wash or shower rooms. Transmitting range 25M ORDER CODE WCP-02 PRICE £42.00 + VAT

Wireless reset button used to reset alarm calls from WCP-02. Transmitting range 25M  ORDER CODE WRE-02 PRICE £42.00 + VAT

Central monitor nurse call station for the display of active transmitter calls. Any number of central monitors can be used within a building displaying the same call information or setup for specific floors or wards.  ORDER CODE CMU-02 PRICE £180.00 + VAT

Signal repeater unit with built in audible alarm with volume control and flashing strobe LED’s. Boosts signals by approximately 50 Metres. Battery operated (24 months) 4 x D cell.  Memory stores 15 transmitter devices. ORDER CODE ILB-03 PRICE £78.00 + VAT

Bed occupancy sensor plugs into BTXV-NCT for residents at risk from falls. Bed leaving reported to nurse call display.
ORDER CODE SEN-1 PRICE £28.00 + VAT

Chair occupancy sensor for use with BTXV-NCT ORDER CODE SEN-2 PRICE £24.00 + VAT

Voice room number announcing pager, battery operated with sturdy belt clip.  ORDER CODE PAG-02 PRICE £26.00 + VAT

All batteries where applicable are included in pricing.